Jump to content


XTI 1000 Sound Cuts Out


  • Please log in to reply
6 replies to this topic

#1 ontime1269

ontime1269
  • Members
  • 2 posts

Posted 13 November 2011 - 11:20 AM

On my XTI 1000 the sound will cut out on Channel 2. It is driving 1 top crossed over at 90hz. Sometimes the sound will come back in on own its on but rarely. Turning the volume all the way up on my mixer always brings the sound back in. This will happen every 5 - 10 minutes or so. I have another XTI 1000 and a XTI 2000 and hooked everything up identically to those to see if there might be another issue within the signal chain. The other 2 XTI's worked flawlessly. Is there possibly a short of some sort within the XTI 1000 in question? Thanks.

#2 ontime1269

ontime1269
  • Members
  • 2 posts

Posted 20 May 2012 - 07:34 AM

Hard to get any answers around here. I was finally able to get my amp repaired. Turned out to be a bad ribbon connector.

#3 dakos

dakos

    Admin

  • Members
  • PipPipPipPipPip
  • 789 posts

Posted 22 May 2012 - 02:47 PM

QUOTE(ontime1269 @ May 20 2012, 07:34 AM) View Post
Hard to get any answers around here. I was finally able to get my amp repaired. Turned out to be a bad ribbon connector.

Good to hear you got it fixed, sorry I couldn't answer, not my strongest area.

#4 technoweenie

technoweenie
  • Members
  • 2 posts

Posted 30 March 2015 - 02:56 PM

View Postontime1269, on 20 May 2012 - 07:34 AM, said:

Hard to get any answers around here. I was finally able to get my amp repaired. Turned out to be a bad ribbon connector.


Do you know which ribbon connector? I have the same problem. I just have to tap on the unit and the sound comes back on.

#5 joust

joust

    Power User

  • Members
  • PipPipPipPipPip
  • 616 posts

Posted 30 March 2015 - 09:25 PM

The ribbon discussed is the one linking the main board to the display board. Furthermore, I would suggest replacing the connector at the same time.
However, Crown has a direct replacement module.

A.

#6 technoweenie

technoweenie
  • Members
  • 2 posts

Posted 05 April 2015 - 02:40 PM

Thanks. I fixed it myself. The connector was a bit loose. I disconnected it, connected it and no more fading in/out now.

#7 joust

joust

    Power User

  • Members
  • PipPipPipPipPip
  • 616 posts

Posted 09 April 2015 - 11:02 AM

Can you let me know what version of the display board you have? (the latest version is 138911-5)

Thanks!

A.