I bought a used PowerBase 2 amp and I want to connect it to two Dynacord CS31 speaker cabinets (8 OHMS Impedance). I'll be connecting an Ashley keyboard mixer, with only one output to the PowerBase 2. How do I connect both Dynacord speakers when there is only one input coming into the Powerbase 2? I'm not fluent in this area. A diagram would be very helpful. Thanks!
0
PowerBase 2 Connect to two Dynacord Cabinets
Started by SteveCoscia, Sep 12 2011 07:01 AM
2 replies to this topic
#2
Tom Lureman
-
- Admin
-
- 111 posts
Network Newbie
Posted 12 September 2011 - 10:12 AM
The easiest thing to do is get a simple Y cable. Plug the Y cable into the mono mixer output, as well as to both channels of the amplifier. This way both channels of the amp will be getting the same audio signal.
#3
SteveCoscia
-
- Members
- 2 posts
Posted 12 September 2011 - 08:17 PM
QUOTE(Tom Lureman @ Sep 12 2011, 11:12 AM) 
The easiest thing to do is get a simple Y cable. Plug the Y cable into the mono mixer output, as well as to both channels of the amplifier. This way both channels of the amp will be getting the same audio signal.
Thanks Tom. Good idea! -Steve
