Hey, I just purchased two XTI's and have a problem getting different mixes with the monitors.I ran two signals from the amp from AUX 1 and 2 in the board. However I cannot get a separate mix for the two channels. The Amp output ch1 and ch2 want to respond like bass and tweeter and I cannot separate the channels. I have made sure the internal crossover is switched off in the setting I am using. However continues to split the Lo and Hi end.
Any suggestions would be great.
1
XTI's unable to deactivate crossover
Started by parkerrobb, Feb 13 2011 06:38 PM
1 reply to this topic
#2
Tom Lureman
-
- Admin
-
- 111 posts
Network Newbie
Posted 15 February 2011 - 09:45 AM
Load Preset 1 "DSP OFF". Try switching inputs 1 and 2 to make sure it's not on the input side. If that doesn't work put the inputs back to their initial state and switch the speakers.
