Notes on 4-ohm bridged / 2-ohm dual operation
Posted 08 February 2011 - 10:52 AM
XLS-D (old): The 802 model technically needs a 20-amp power supply to run this way. The old XLS series tends to overheat anyway with these loads, so we don't recommend doing it.
iTech/HD, MAi: These amps run on an extremely high voltage rail and will need to current-limit to run on these loads. So power begins dropping off below 8-ohms bridged/4-ohms dual.
Note on combining 2 or more 8-ohm speakers in parallel: There will be spots on the impedance curve, usually just above and below speaker resonance, where the impedance will be BELOW 8-ohms. Therefore, the amp will actually see a load LESS THAN 4-ohm bridged / 2-ohm dual when combining these speakers in parallel, and may react badly to it. Just something to be aware of.
Posted 27 February 2011 - 04:14 PM
How about running them in series/parallel to keep the impedance up. And if so, I never saw any body talk about reversing the wiring on your Speakon connectors so they would be + to - (series) instead of + to + (parallel)?
Posted 01 March 2011 - 02:26 PM
Posted 04 March 2011 - 12:53 AM
Posted 04 March 2011 - 07:50 AM
Posted 30 April 2011 - 09:25 AM
Posted 03 May 2011 - 02:49 PM
Posted 13 February 2012 - 10:52 PM
im running the amp in bridged mono with the wires setup asper the specifications of the amp i rewired the speakon wires to match whatever the amp needed
Posted 17 May 2012 - 11:20 AM
Posted 15 July 2012 - 03:50 AM
It's going to enough but , you won't get 100% of the juice out of the subs.