Jump to content


2 XTI 1000 No Output.


  • Please log in to reply
3 replies to this topic

#1 RSquared

RSquared
  • Members
  • 3 posts

Posted 17 November 2010 - 10:49 PM

I just took delivery of 2 Xti 1000s.  Both were built earlier this year.  I am running one stereo on tops and one bridge mono on subs.  I set up all my DSP settings with Band Manager.  Got everything set and hooked up.  Turned up the volume and nothing...  On the software they aren't muted.  Input signal is there.  But when I turn up the levels nothing goes to the output and there is no sound.  The trouble shooting part of the manual show different error codes with the front LED's.  I am not getting either of those errors.  I shut down band manager and tried to use just the panel controls and no change.  I used system architect to reflash the firmware(even though it was the latest release) and nothing changed.  I am in panic mode.  I bought these for a party I have this Sat, and I can't figure out the issue.  All assistance appreciated.  I am lost.  If it was just one amp, I would think bad amp...but 2, I am thinking a problem with my settings.  I tried with no dsp as well and nothing.

#2 Tom Lureman

Tom Lureman

    Network Newbie

  • Admin
  • 111 posts

Posted 18 November 2010 - 08:49 AM

What is your input source?

Are you seeing the signal LED's light up?

Set the amp to the "DSP Off" setting using the front panel controls and try and run your tops.

#3 RSquared

RSquared
  • Members
  • 3 posts

Posted 18 November 2010 - 08:53 AM

QUOTE(Tom Lureman @ Nov 18 2010, 07:49 AM) View Post
What is your input source?

Are you seeing the signal LED's light up?

Set the amp to the "DSP Off" setting using the front panel controls and try and run your tops.

I tried inputing from my mixing console and a dj mixer.  No sound.  Yes the signal led's are lit and in Band manager you can see signal levels.  I tried with dsp off as well with nothing.

#4 RSquared

RSquared
  • Members
  • 3 posts

Posted 18 November 2010 - 10:07 AM

Never mind, I am an idiot.  I thought band manager controlled the levels.  But you have to turn up the pots and band manager.