I'm trying to control a PS8810C via IR remote.
I succeded in it, but only if the ProSys IQ address is set to 1.
I changed the address to 2, i.e., and I recompiled all the IR Codes aiming that address, but without success.
I'm quite sure that the RC5x codes I can set are correct.
So, my question is: is a PS8810C controllable via IR code, even if its IQ address is different from 1?
PS8810 IR control
1 reply to this topic
Posted 03 May 2005 - 04:22 PM
I am being told that the PS-8810 IR should respond at any IQ address if the IR remote is programed with the correct IQ address and code. I will check into it further though and see if I can find anything.