Posted 03 October 2010 - 07:01 AM
I see online too, people using Bandmanager, and they have a rack full of amps showing.
So I get an XLR and go from the Out/Link from one amp, and then into the Input of the next amp. Open Bandmanager...Nothing Only 1 of the 3 amps I have, are showing in BM.
Maybe I have it hooked up wrong. I swap directions...Still Nothing....!!!!
I read the pdf Manual, search Google and Yahoo. Did a search here on how to Link Multiple Amps. Nothing, not a single Drawing, direction, anything out there showing how to hook up more than one amp, and view them in Bandmanager.
I challenge anyone to do a search through Google and the Manuals, you won't find anything, anywhere, on how to hook up more than one XTI amp. You won't find anything. Not a picture, drawing, diag, note, instructions...nadda.
Anyone been lucky and actually had more than one amp, showing in BM?
Posted 04 October 2010 - 03:16 PM
The first XTi 4000 will run the Main Speakers, and then the second XTi 4000 will run the Subs. Correct? I am I on to something? Come one, you of you guys reading this should have an answer, don't be leaving the new guy hanging here. Or are you just looking for something to read? 20 Views, and not one answer.
Geesh! This might take a few weeks.
Posted 04 October 2010 - 04:02 PM
Just like my post above. Must use the USB Hub, and 2.0 USB Cables. Hook up the USB Hub to my Laptop, then using a 2.0 USB Cable, hook each amp into the Hub. Fire up Bandmanager. Each amp should be recognized in BM.
Link/Out ~ just as I thought. Send the Signal from my Mixing Board to one Amp. Then send the signal from this amp to the next amp, using a Female XLR/Male XLR cable. The signal will go to both amps. Then I can set the crossover points for the first amp (Mains) and set the crossover for the second amp (Subs).
Posted 07 October 2010 - 08:37 AM
Posted 07 October 2010 - 08:44 PM
Now, onto Wireless transmission over 100'