Jump to content


IQwic Responds but can't see


  • Please log in to reply
1 reply to this topic

#1 dsgamermike

dsgamermike
  • Members
  • 2 posts

Posted 29 January 2010 - 09:39 PM

I have a ct400 with the usp 3 card in it. When I'm' in iqwic I can change eq's, change the output gain. The whole 9 yards. There is signal passing through the amp and it is working normally. The problem is that I don't see input, output or thermal graphs. The other thing that I can not do is change the frequency of the noise generator. I can how ever control the volume of it. Even if there was no audio passing through it, the generator would make the bars. So there's something up. Any Ideas?

Forgot to add that error log pops up saying the device appears to be dead. I have changed out the network cables also.





#2 dsgamermike

dsgamermike
  • Members
  • 2 posts

Posted 29 January 2010 - 09:53 PM

I fixed it. I had to create a new oif file.