I have the orginal pip cards in my IQ System and I need to cahnge the address on one card, or I need to figure out the address. so if anyone could give me the code for the dip switches so that I can interpret or cahnge them that would be great.
Thanks
2
Setting PIP Address
Started by bakkker7544, Feb 25 2005 10:53 AM
2 replies to this topic
#2
Bradford Benn
-
- Admin
-
- 1,025 posts
Power User
Posted 25 February 2005 - 11:09 AM
The address table is located in the owner's manuals. You can find them at: http://www.crownaudio.com/gen_htm/legacy/legaciq.htm
#3
DGlass
-
- Members
-
- 2,541 posts
.
Posted 25 February 2005 - 12:37 PM
Some of the older cards used a Red Dip Switch that you had to Push the tabs down to set them to on. I have attached an Address table from the USP-2 it's the same Binary is Binary whether you push the switch up or Down.
There is currently not a manual available for the original IQ-PIP module in .pdf. I will work on getting it scanned in and posted on the Legacy Discontinued Products web page as soon as possible.
There is currently not a manual available for the original IQ-PIP module in .pdf. I will work on getting it scanned in and posted on the Legacy Discontinued Products web page as soon as possible.
Attached Files
-
AddressTables.pdf 504.81K
44 downloads
