Jump to content


PS8810 copy/paste ?


  • Please log in to reply
1 reply to this topic

#1 Jean-Pierre Toussaint

Jean-Pierre Toussaint
  • Members
  • 6 posts

Posted 08 February 2005 - 09:15 AM

I've been trying on IQ 5.1.2.0 to copy/paste filters from one output to another. It works the first time but never works since. I've tryed offline, online, on a new design, etc. When i paste, it opens the paste dialog. I click OK and it seems to engage it but nothing change on the filter block.

Any ideas ???

Thanks
JP

#2 DGlass

DGlass

    .

  • Members
  • PipPipPipPipPip
  • 2,541 posts

Posted 08 February 2005 - 09:28 PM

JP

I can't say that I've ever seen this happen but try this:
Open the two units to their "Signal Path" control page. From here you will see the flow diagram with the control blocks being used highlighted. If you drag the control block from one unit to the other the settings will copy just like in copy and paste.