3 replies to this topic

[whuntree]

Gidday all,
In SA version 1.50.1.0 I’ve made a custom control panel to display 4x XTi 4000 output temps using 2 gradient meters to display channel 1 & 2 output temps for each amp.  When the amp is in stereo mode both temps are displayed as expected but when the amp is in Bridge mode only output temp 1 is displayed.  Obviously both output channels are being driven in bridge mode so how do I get both meters to display in stereo mode ??

Thanks,
Rod.

[whuntree]

Gidday all,
In SA version 1.50.1.0 I’ve made a custom control panel to display 4x XTi 4000 output temps using 2 gradient meters to display channel 1 & 2 output temps for each amp.  When the amp is in stereo mode both temps are displayed as expected but when the amp is in Bridge mode only output temp 1 is displayed.  Obviously both output channels are being driven in bridge mode so how do I get both meters to display in stereo mode ??

Thanks,
Rod.

Sorry, I ment to say how do I get both meters to display correctly in "Bridge mode"

[DGlass]

Gidday all,
In SA version 1.50.1.0 I’ve made a custom control panel to display 4x XTi 4000 output temps using 2 gradient meters to display channel 1 & 2 output temps for each amp.  When the amp is in stereo mode both temps are displayed as expected but when the amp is in Bridge mode only output temp 1 is displayed.  Obviously both output channels are being driven in bridge mode so how do I get both meters to display in stereo mode ??

Thanks,
Rod.

Sorry, I ment to say how do I get both meters to display correctly in "Bridge mode"

I was able to duplicate the issue and have it reported as a possible bug.
Thanks for letting us know.

[whuntree]

Impatient little bugger aren't I.....sorry about that.  
Thanks for pursuing the problem.  Now I can stop pulling my hair out for a bit.  

Regards,
Rod.