Hello,
how can I use the limiters in IT-4000, particularly in average watts. do I have to configure the monitoring page in the software.
0
Itech advance features
Started by hotgem, Jul 07 2004 08:31 AM
2 replies to this topic
#2
KGring
-
- Crown Staff
-
- 84 posts
Power User
Posted 12 July 2004 - 08:50 AM
Hello,
You can use step through the advanced settings from the front panel LCD and turn on and set the average power limiters, or you can use the software and turn the limiters on from the control page.
You can use step through the advanced settings from the front panel LCD and turn on and set the average power limiters, or you can use the software and turn the limiters on from the control page.
Kevin B. Gring
Crown Audio
kgring@crownintl.com
Crown Audio
kgring@crownintl.com
#3
MKellom
-
- Crown Staff
-
- 2 posts
Posted 26 July 2004 - 11:21 PM
To clarify a bit further:
Average power limiters can be enabled or disabled from the front panel, but there is another setting some users may want to modify.
The average power limiter calculates power based on a nominal impedance setting that is configured in IQWic. On the "load monitoring" tab, set the nominal impedance to match the connected load. The average power limiter will then limit based on this value.
The peak voltage limiter can be fully configured from the front panel of I-Tech, and is another way to protect drivers when necessary.
Marc
Average power limiters can be enabled or disabled from the front panel, but there is another setting some users may want to modify.
The average power limiter calculates power based on a nominal impedance setting that is configured in IQWic. On the "load monitoring" tab, set the nominal impedance to match the connected load. The average power limiter will then limit based on this value.
The peak voltage limiter can be fully configured from the front panel of I-Tech, and is another way to protect drivers when necessary.
Marc
