1 reply to this topic

[venturam]

I'm currently using TCP/IQ UDP commands to communicate between a Crestron RACK2 processor and a MA5002VZ using a USP3 PIP.  I would like to be able to reset the amplifier to factory defaults without having to physically push the reset at the amplifier or having to send multiple command strings resetting states.

I have scanned the .OIF command list and did not see a register state where I could set/reset the amplifier.  Is there any single command I can send to the amplfier to have it reset to factory defaults?

Marc

[Bradford Benn]

The cleanest way to do that would be to store a "blank" preset of factory defaults and just recall that when you need to zero the unit out.