Jump to content


crown MA5002vz


  • Please log in to reply
1 reply to this topic

#1 PROMOCIONESRUIZ

PROMOCIONESRUIZ
  • Members
  • 14 posts

Posted 06 October 2006 - 06:34 PM

Can


   a crown MA5002VZ Go bad and destroy speakers?  I recently bought a used crown  hooked up to new eaw  rated 2000watts in a matter of time the speakers fried not peaking the amp or over driving it.... I am afraid to try more since I don't know if it was the amp? is there a way to test the output with a meter?

#2 DGlass

DGlass

    .

  • Members
  • PipPipPipPipPip
  • 2,541 posts

Posted 09 October 2006 - 10:04 AM

Under normal circumstances the protection circuits of the amp should keep things good to go. However if the signal was distorted before the amp the amp would amplify it to the speakers.

To meter the amp you would need an Oscilliscope to look at the output and to service the amp I would recommend getting the Service Manual from our parts department.

Since you bought the amp used you should probably have it looked at by a service center anyways.