Jump to content


Problems With Ultra tech 1010


  • Please log in to reply
1 reply to this topic

#1 z9laserr

z9laserr
  • Members
  • 1 posts

Posted 04 October 2006 - 12:09 PM

dry.gif  HI! My Ultra-Tech 1010 amp has no fault signal in the front panel but for some reason has no output in any of the two channels. I make differents changes of wiring and speakers but the wiring and the speakers are in exellent condition.

  I use this amp exclusive for my guitar processor Digitech 2101 in stereo mode and always take good care it. The input signal light comes on when I play the guitar and the processor output is working because I verify with other amps. I always take care not to turn on the clip signal because I use a very low sound compare with the power of the crow amp. I verify visually inside of the amp but I don't see any burnt or damage component. Please let me know what I can do or if you can send to me a electronic circuit schematic because according to the online manual if the amp has no output it's suppose to turn on the fault signal but it does not.  

Thanks
Z9laserr

#2 DGlass

DGlass

    .

  • Members
  • PipPipPipPipPip
  • 2,541 posts

Posted 05 October 2006 - 03:38 PM

The UT1010 is basically a CE1000 with a different label.
Schematics and service manual for the CE1000 can be found on our web site at:

http://www.crownaudio.com/gen_htm/legacy/legacamp.htm
smile.gif