USP3 idGetState for LevelSensors
Posted 03 March 2004 - 01:58 PM
Posted 03 March 2004 - 03:26 PM
When I issue an idGetState command with two queries built into one message (Count=2) such as
Query Ch1 power state (ID=07D0)
Query Ch1 load impedance (ID=088A)
The formatted response only contains the power state data (BinaryControl). The load impedance (LevelSensor) data request is apparently ignored.
Posted 10 March 2004 - 01:19 PM
Posted 11 March 2004 - 04:59 PM
Posted 12 March 2004 - 09:10 AM
I have sent these commands and waited for some time (a min or so) for a response without receiving any. I am able to get responses from get state commands for anything dealing with controls but fail to get a response from a get state sensor request even after waiting.
Perhaps its my command string I am sending the following string from the crestron unit to request a getstate from a level sensor (in this case channel 1 Z average):
4951 00000014 0007 0100 FA64 0000 0003 0001 088A
When I send this string I get no response. Also of interest is the fact I will not get any error responses from the amplifier to the crestron if I send an incorrect code/ id object request. I ONLY get a response from the amplifier for a getstate control request.
Posted 16 March 2004 - 04:36 PM
The only questions I can think to ask are:
1 - your're sending to port 5600, right?
2- your PIP is at IQ address 3, right?
3 - are there any routers/gateways involved, or are you on the same subnet as the PIP?
Posted 23 April 2004 - 08:36 AM
Manager, Global Ecommerce
HARMAN Professional Services