Jump to content


Bridge (Mono) Question?


  • Please log in to reply
2 replies to this topic

#1 Lowell2k9

Lowell2k9
  • Members
  • 10 posts

Posted 28 February 2012 - 02:50 PM

Hello all, I have 2 Crown XTI 4002's & 2 JBL srx718 subs, and 100' speakon N4 cable.  I want to run them one amp for each sub.
This is where Im stuck. I cut the 100' cable in half, now im trynna add the connectors to the amp side of cable & connector for sub side.
Is this the correct way to connect this (for amp +1 and +2) and (for subs -1 and -2)?  Also do i go into channel 1 for each amp?  thanks again.

#2 dakos

dakos

    Admin

  • Members
  • PipPipPipPipPip
  • 744 posts

Posted 28 February 2012 - 03:02 PM

QUOTE(Lowell2k9 @ Feb 28 2012, 02:50 PM) View Post
Hello all, I have 2 Crown XTI 4002's & 2 JBL srx718 subs, and 100' speakon N4 cable.  I want to run them one amp for each sub.
This is where Im stuck. I cut the 100' cable in half, now im trynna add the connectors to the amp side of cable & connector for sub side.
Is this the correct way to connect this (for amp +1 and +2) and (for subs -1 and -2)?  Also do i go into channel 1 for each amp?  thanks again.

Speaker side Positive lead to (+1), Negative lead to (-1).
Amp side Positive wire to (+1) and the negative wire to (+2).
Connect the Amp side of the cables to channel 1 only on each amp.

#3 Lowell2k9

Lowell2k9
  • Members
  • 10 posts

Posted 28 February 2012 - 05:52 PM

Thanks Dakos.