Jump to content


I-Tech....Y input?


  • Please log in to reply
1 reply to this topic

#1 rezsbc

rezsbc

    Power User

  • Members
  • PipPipPipPipPip
  • 36 posts

Posted 26 September 2005 - 06:02 AM

Hey,

I'm sure I'm doing something really stupid but when I set an I-Tech 6000 up the other day it seemed to be stuck on "Y" input no matter what setting I made on the IQ-Wic software (on the block diagram screen for the amp).  

Is there something I'm missing here is there somewhere else this can be set?  Need to run in stereo.

ites.,

cathal.

#2 Bradford Benn

Bradford Benn

    Power User

  • Admin
  • 1,025 posts

Posted 26 September 2005 - 08:05 PM

QUOTE(rezsbc @ Sep 26 2005, 06:02 AM)
Hey,

I'm sure I'm doing something really stupid but when I set an I-Tech 6000 up the other day it seemed to be stuck on "Y" input no matter what setting I made on the IQ-Wic software (on the block diagram screen for the amp). 

Is there something I'm missing here is there somewhere else this can be set?  Need to run in stereo.

ites.,

cathal.
View Post


There are actually two places you can make this adjustment. One is the input "Y" as you mentioned. The other place to check is the Input Section and make sure that the amplifiers are receiving signal from the proper channels

Attached Files


-=Brad

Bradford Benn
Business Development Manager - Crown International
http://www.crownaudio.com/