Jump to content


IQ INTERFACE


  • Please log in to reply
3 replies to this topic

#1 studio

studio
  • Members
  • 2 posts

Posted 17 October 2007 - 12:08 PM

I have a iq interface.  I'm wanting to control some White Instruments 4700-2IQ Equalizers.  What software would I use?  Theirs or yours?

#2 DGlass

DGlass

    .

  • Members
  • PipPipPipPipPip
  • 2,541 posts

Posted 23 October 2007 - 12:52 PM

QUOTE(studio @ Oct 17 2007, 01:08 PM) View Post
I have a iq interface.  I'm wanting to control some White Instruments 4700-2IQ Equalizers.  What software would I use?  Theirs or yours?

You would need the IQ for Windows 5.12 software. With that said there was a firmware update chip that was needed to make the older versions of the White 4700 EQ work with IQwin. I am not sure if this is still available or not. However give it a try with the IQ for Windows software.

If IQwin doesn't work the other choice is to use the IQ Turbo software. However to do this you will need a computer running on DOS or Windows 95 to allow the Turbo software to work.

#3 studio

studio
  • Members
  • 2 posts

Posted 24 October 2007 - 01:20 PM

Can some one help me with this error?
What does it mean?




#4 DGlass

DGlass

    .

  • Members
  • PipPipPipPipPip
  • 2,541 posts

Posted 31 October 2007 - 03:56 PM

QUOTE(studio @ Oct 24 2007, 02:20 PM) View Post
Can some one help me with this error?
What does it mean?


This means that the software has seen something on Loop 3 of the Interface but there is a break in the loop so it can not communicate. This could also be a miss-wireing on one of the Loop connectors or a bad component that has broken the data Loop.