I have a iq interface. I'm wanting to control some White Instruments 4700-2IQ Equalizers. What software would I use? Theirs or yours?
1
IQ INTERFACE
Started by studio, Oct 17 2007 12:08 PM
3 replies to this topic
#2
DGlass
-
- Members
-
- 2,541 posts
.
Posted 23 October 2007 - 12:52 PM
QUOTE(studio @ Oct 17 2007, 01:08 PM) 
I have a iq interface. I'm wanting to control some White Instruments 4700-2IQ Equalizers. What software would I use? Theirs or yours?
You would need the IQ for Windows 5.12 software. With that said there was a firmware update chip that was needed to make the older versions of the White 4700 EQ work with IQwin. I am not sure if this is still available or not. However give it a try with the IQ for Windows software.
If IQwin doesn't work the other choice is to use the IQ Turbo software. However to do this you will need a computer running on DOS or Windows 95 to allow the Turbo software to work.
#3
studio
-
- Members
- 2 posts
Posted 24 October 2007 - 01:20 PM
Can some one help me with this error?
What does it mean?
What does it mean?
#4
DGlass
-
- Members
-
- 2,541 posts
.
Posted 31 October 2007 - 03:56 PM
QUOTE(studio @ Oct 24 2007, 02:20 PM)
Can some one help me with this error?
What does it mean?
What does it mean?
This means that the software has seen something on Loop 3 of the Interface but there is a break in the loop so it can not communicate. This could also be a miss-wireing on one of the Loop connectors or a bad component that has broken the data Loop.
