I am busy upgrading a Itech 6000 to Ver 1.3 and get an error message in iqwic (7.2)
1 possible OIF mismatch:unknown object id 2060 in statedata after id 2045
2166 2164
3060 3045
3166 3164
The amp is working OK
Thanks
Stephen
1
Ver 1.3 error
Started by StephenHoy, May 05 2005 02:20 AM
2 replies to this topic
#1
StephenHoy
-
- Members
- 4 posts
Posted 05 May 2005 - 02:20 AM
Hi
I am busy upgrading a Itech 6000 to Ver 1.3 and get an error message in iqwic (7.2)
1 possible OIF mismatch:unknown object id 2060 in statedata after id 2045
2166 2164
3060 3045
3166 3164
The amp is working OK
Thanks
Stephen
I am busy upgrading a Itech 6000 to Ver 1.3 and get an error message in iqwic (7.2)
1 possible OIF mismatch:unknown object id 2060 in statedata after id 2045
2166 2164
3060 3045
3166 3164
The amp is working OK
Thanks
Stephen
#2
DGlass
-
- Members
-
- 2,541 posts
.
Posted 05 May 2005 - 08:21 AM
Stephen,
Did you copy over the .oif file that came with the firmware download into the directory that the IQwic 7.20 software is located. There were some upgrades to the .oif control file that were made after the release of the software and the subsequent release of the I-Tech 1.3 firmware. So without doing new release of the software for one .oif file we provided the file in the firmware download this time.
Did you copy over the .oif file that came with the firmware download into the directory that the IQwic 7.20 software is located. There were some upgrades to the .oif control file that were made after the release of the software and the subsequent release of the I-Tech 1.3 firmware. So without doing new release of the software for one .oif file we provided the file in the firmware download this time.
#3
StephenHoy
-
- Members
- 4 posts
Posted 05 May 2005 - 09:48 AM
QUOTE(DGlass @ May 5 2005, 08:21 AM)
Stephen,
Did you copy over the .oif file that came with the firmware download into the directory that the IQwic 7.20 software is located. There were some upgrades to the .oif control file that were made after the release of the software and the subsequent release of the I-Tech 1.3 firmware. So without doing new release of the software for one .oif file we provided the file in the firmware download this time.
Did you copy over the .oif file that came with the firmware download into the directory that the IQwic 7.20 software is located. There were some upgrades to the .oif control file that were made after the release of the software and the subsequent release of the I-Tech 1.3 firmware. So without doing new release of the software for one .oif file we provided the file in the firmware download this time.
Thanks David all is now well
Stephen
