Jump to content


ITech in bridged mono


  • Please log in to reply
2 replies to this topic

#1 paultucci

paultucci
  • Members
  • 8 posts

Posted 10 June 2006 - 07:17 PM

Once again I don't have an amp in front of me but I am designing. What happens in bridged mono mode? Will both channels of processing show up still? Does one need to treat both channels the same? ie add the same delay to both sides? Or will just one processing side appear and everything is done there?

Paul Tucci

#2 DGlass

DGlass

    .

  • Members
  • PipPipPipPipPip
  • 2,541 posts

Posted 12 June 2006 - 08:40 AM

Both channels of processing will show up but only channel one will be doing anything. In the Bridge-Mono mode it is the output of the channel 1 processing that is sent to both amplification stages. smile.gif

#3 paultucci

paultucci
  • Members
  • 8 posts

Posted 15 June 2006 - 08:57 AM

QUOTE(DGlass @ Jun 12 2006, 09:40 AM)
Both channels of processing will show up but only channel one will be doing anything. In the Bridge-Mono mode it is the output of the channel 1 processing that is sent to both amplification stages. smile.gif
View Post



Thank you David