I have a Crown XLS 202 that one channel has gone completely dead on.The fault light is fine.Any ideas where to start looking for the problem?The amp is only used for a couple of monitors so has seen light use.
2
Crown XLS 202 channel problem
Started by dustee, Oct 04 2005 08:48 AM
4 replies to this topic
#2
Bradford Benn
-
- Admin
-
- 1,025 posts
Power User
Posted 04 October 2005 - 10:17 AM
QUOTE(dustee @ Oct 4 2005, 08:48 AM)
I have a Crown XLS 202 that one channel has gone completely dead on.The fault light is fine.Any ideas where to start looking for the problem?The amp is only used for a couple of monitors so has seen light use.
It should still be under warranty, so the first thing I would do is recommend getting a local service center to look at it or contact Crown for a repair.
#3
dustee
-
- Members
- 3 posts
Posted 04 October 2005 - 05:20 PM
QUOTE(Brad Benn @ Oct 4 2005, 10:17 AM)
QUOTE(dustee @ Oct 4 2005, 08:48 AM)
I have a Crown XLS 202 that one channel has gone completely dead on.The fault light is fine.Any ideas where to start looking for the problem?The amp is only used for a couple of monitors so has seen light use.
It should still be under warranty, so the first thing I would do is recommend getting a local service center to look at it or contact Crown for a repair.
#4
dustee
-
- Members
- 3 posts
Posted 04 October 2005 - 05:23 PM
QUOTE(Brad Benn @ Oct 4 2005, 10:17 AM)
QUOTE(dustee @ Oct 4 2005, 08:48 AM)
I have a Crown XLS 202 that one channel has gone completely dead on.The fault light is fine.Any ideas where to start looking for the problem?The amp is only used for a couple of monitors so has seen light use.
It should still be under warranty, so the first thing I would do is recommend getting a local service center to look at it or contact Crown for a repair.
Thanks for your reply Brad.I'm not sure if it's under warranty or not but I would just as soon have a look at it myself.I
ve built a few amps from scratch and have test equipment.Was just looking for a little advice on a good place to start as I'm a bit rusty on solid state stuff.
#5
DGlass
-
- Members
-
- 2,541 posts
.
Posted 05 October 2005 - 02:23 PM
QUOTE(dustee @ Oct 4 2005, 05:23 PM)
QUOTE(Brad Benn @ Oct 4 2005, 10:17 AM)
QUOTE(dustee @ Oct 4 2005, 08:48 AM)
I have a Crown XLS 202 that one channel has gone completely dead on.The fault light is fine.Any ideas where to start looking for the problem?The amp is only used for a couple of monitors so has seen light use.
It should still be under warranty, so the first thing I would do is recommend getting a local service center to look at it or contact Crown for a repair.
Thanks for your reply Brad.I'm not sure if it's under warranty or not but I would just as soon have a look at it myself.I
ve built a few amps from scratch and have test equipment.Was just looking for a little advice on a good place to start as I'm a bit rusty on solid state stuff.
If you will contact me directly at dglass@crownintl.com I will send you the schematic.
As the XLs amps have not been out for three years yet factory service would still be covered under warranty
