Jump to content


XTI2000 in Bridge or Stereo


  • Please log in to reply
3 replies to this topic

#1 piruloy2k

piruloy2k
  • Members
  • 7 posts

Posted 28 November 2011 - 07:31 PM

Hi Team;
Actually I'm running  my two (2) XTI2000 amps with this config:

one xti2000 in Stereo Mode with two (2) 8-omh speakers on each Channel, on pararell (4omh both channels)
one xti2000 in Bridge Mode with two (2) 8-omh subs connected in parallel to channel one (4 omh load)

Surely on my Subs amplifier I think I have the best setup . If not, let me know.

In case of the other amp, is this setup OK, or how I can get the most of this Amp?
Can I run in on Bridge mode and connect all four speakers in parallel to a 2omh load?
Can this improve my sound power?

Thanks;
Carlos Brea
Puerto Rico

#2 Stephane

Stephane

    Power User

  • Members
  • PipPipPipPipPip
  • 269 posts

Posted 28 November 2011 - 10:12 PM

QUOTE(piruloy2k @ Nov 28 2011, 07:31 PM) View Post
Hi Team;
Actually I'm running  my two (2) XTI2000 amps with this config:

one xti2000 in Stereo Mode with two (2) 8-omh speakers on each Channel, on pararell (4omh both channels)
one xti2000 in Bridge Mode with two (2) 8-omh subs connected in parallel to channel one (4 omh load)

Surely on my Subs amplifier I think I have the best setup . If not, let me know.

In case of the other amp, is this setup OK, or how I can get the most of this Amp?
Can I run in on Bridge mode and connect all four speakers in parallel to a 2omh load?
Can this improve my sound power?

Thanks;
Carlos Brea
Puerto Rico

Minimum load in bridged mode is 4 ohms

#3 Tom Lureman

Tom Lureman

    Network Newbie

  • Admin
  • 111 posts

Posted 29 November 2011 - 09:45 AM

Do not plug in all 4 speakers to make a 2ohm load on bridge mode.  Like Stephane said, 4ohms is the minimum in bridge mode.  In stereo it can go down to 2ohms per channel.

#4 piruloy2k

piruloy2k
  • Members
  • 7 posts

Posted 29 November 2011 - 08:49 PM

QUOTE(Tom Lureman @ Nov 29 2011, 10:45 AM) View Post
Do not plug in all 4 speakers to make a 2ohm load on bridge mode.  Like Stephane said, 4ohms is the minimum in bridge mode.  In stereo it can go down to 2ohms per channel.



Ok thanks for the suggestions!