Hello all, I have 2 Crown XTI 4002's & 2 JBL srx718 subs, and 100' speakon N4 cable. I want to run them one amp for each sub.
This is where Im stuck. I cut the 100' cable in half, now im trynna add the connectors to the amp side of cable & connector for sub side.
Is this the correct way to connect this (for amp +1 and +2) and (for subs -1 and -2)? Also do i go into channel 1 for each amp? thanks again.
1
Bridge (Mono) Question?
Started by Lowell2k9, Feb 28 2012 02:50 PM
2 replies to this topic
#2
dakos
-
- Members
-
- 493 posts
Power User
Posted 28 February 2012 - 03:02 PM
QUOTE(Lowell2k9 @ Feb 28 2012, 02:50 PM) 
Hello all, I have 2 Crown XTI 4002's & 2 JBL srx718 subs, and 100' speakon N4 cable. I want to run them one amp for each sub.
This is where Im stuck. I cut the 100' cable in half, now im trynna add the connectors to the amp side of cable & connector for sub side.
Is this the correct way to connect this (for amp +1 and +2) and (for subs -1 and -2)? Also do i go into channel 1 for each amp? thanks again.
This is where Im stuck. I cut the 100' cable in half, now im trynna add the connectors to the amp side of cable & connector for sub side.
Is this the correct way to connect this (for amp +1 and +2) and (for subs -1 and -2)? Also do i go into channel 1 for each amp? thanks again.
Speaker side Positive lead to (+1), Negative lead to (-1).
Amp side Positive wire to (+1) and the negative wire to (+2).
Connect the Amp side of the cables to channel 1 only on each amp.
