Sixstring

CS1200

2 posts in this topic

I am doing an install using CTs series Amps. The FOH will use a 2000, the Subs a 3000, the monitors 2, 1200's and the downfill and frontfill using a 600. I am connecting two pair of speakers (8 Ohm), 2 down fills and 2 front fills, to the CTs 600. There will be one signal for the fills coming from the A&H mixer, passing through a BSS Soundweb 3088. Can I connect the speakers at the amp terminal strip output together? 2 positive speaker wires with terminal forks together & two negative speaker wires with terminal forks on channel one, then the same for channel two? I normally would connect speaker to speaker for channel one, then speaker to speaker for channel two but the wiring is home run back to the amp rack from each fill. Is it ok to combine the terminals together at the amp? Also would the correct setting be "Daul Mode", "Y" on?

Thanks,

Six

Share this post


Link to post
Share on other sites

Given the description, you will be fine paralleling the speakers at the terminal blocks. Also you would use the "Y" to send the signal to both channels.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now