Sign in to follow this  
Followers 0
Wry The Bteam

XTi 2002 no output signal

2 posts in this topic

Hey people i have just connected my new xti 2002 to bandmanager 2

input is mono into Ch 1 (Y)

Ch 1 output is going to subs

Ch 2 output is going to mid/high boxes

Output mode is in Dual

In Band manager 2 I have setup the Xover to 135 Hz, i have also setup a hard limit at 35v for both outputs. There are no EQs activated.

The problem is is that i can see the input signal coming in from my desk but cannot see any output signal. When i turn the amp up via the knobs on the front panel there is no sound coming out of the speakers. However, when i go into the input section i can activate the pink noise and it comes out of the speakers.

Also if i crank the input gain right up beyond clipping and turn the channels right up i can hear the sound leaking through the amp..

The pink noise works fine so ive got the PA hooked up correctly, im assuming im missing something on the sofware setup side of things.

Any help or suggestions would be greatly appreciated.

Share this post

Link to post
Share on other sites

Does the unit operate well (pass signal) in Dual mode and preset DSP OFF?

When the unit has finished booting up, the Ready indicators should come on.

With signal coming in, the Signal led (second led from bottom) should be lit. If it is not, verify and confirm you have signal coming to the XTI.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  
Followers 0