Sign in to follow this  
Followers 0
twister1264

Micro-tech 1200 Fanformer Output Voltage.

2 posts in this topic

Amcron Micro-tech 1200 with a D6304B2 board. Found fan seized. Un-siezed fan, Fanformer windings brown and when powering up it gets hot. Suspect short circuit. Disconnected output to main board and fanformer runs cool. Visual inspection found power supply components on main board capacitor C4 brown/burnt and has full continuity running through it.

I'm just wondering what the output of the secondary output should be on the transformer which powers the main board? I've measured around 24v AC on the red and blue wires.

Some say it should be 15v and others say 18v. Looking at a schematic from another Crown Amp with the same main board it says 24v. Bit confused.

Thanks.

Share this post


Link to post
Share on other sites

It should be twice 24VAC, with reference to the white wire; It is then reduced to +/-15V via regulators. Note : a 24VDC is derived and used to enable the relays in MA amps. There is no relay in MT units.

Alain

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0