Sign in to follow this  
Followers 0
Recording Engineer

Crown K Series Problem

2 posts in this topic

Picked-up a used Crown K1 and K2 from the same seller. They both hum while signal is going through them and goes away within a few seconds after signal stops (due to the Sleep Mode circuit). Also have a Yamaha P2075 from the same seller and it's quiet as can be the entire time under the exact same conditions/tests as the K1 and K2. Tried three different power circuits, lifted grounds, etc., and still the same results every time. It's weird both the Crowns have exactly the same problem, unless it's some sort of power supply problem and both amps were subjected to the same "A/C punishment". Any thoughts? Thank you.

Share this post


Link to post
Share on other sites

Hello RE,

Probably, you have filter cap issues (output module); You will find broken solder connections on the cap leads. This will cause premature failure of the filter caps. If the caps have leaked or domed, I recommend the replacement of the (4) filter caps, (2 x 8200uF, 110V for each output module); Also, meticulously resolder any potentially cold solder connection on both output modules, resolder jacks and mounts on the i/p board, led components on the display board, retighten output binding posts (remove and reinstall binding posts), and verify and resolder all power connectors.

Furthermore, replace the two caps, C23 and C24 (100uF 25V), in the SMPS negative supply (-13V) section. And don't forget to adjust the ULOL (under lap/over lap) settings! :)

Hope this helps!

Alain

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0