jaymo

xti in bridge mode

7 posts in this topic

It sounds like you want the bridge power but to connect it in stereo or dual mono, am I correct? This can't be done...

Avi

Share this post


Link to post
Share on other sites

Is it possible to run the xti amps in bridge mode and get signal at both outputs?

No, when you bridge an amp it essentially becomes a single channel amp.

Share this post


Link to post
Share on other sites

Okay. Thanks. I was hoping to run 2 speakers off of it in bridge mode without having to link from one speaker to another. Would it be acceptable to make a y cable coming out of output 1 and run to the separate speakers that way in bridge mode? I would be fine load wise at 4 ohms.

Share this post


Link to post
Share on other sites

No, you can either do bridge or stereo, not both.

If you tell us what it is you're trying to do we can assist you much more...

Avi

Share this post


Link to post
Share on other sites

You can drive two speakers in parallel off the bridged output but they'll both get the same mono signal, of course. Using an Y adaptor or going from speaker 1 to speaker 2 daisychained will do the same. Be careful with a 4 ohms load on a bridged amplifier, this is a tough load for any amp.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now