2dmax

connections

3 posts in this topic

Hi guys hope am in the right place, i would like to know is, how to connect my subs when using BRIDGE MONO or BRIDGE SUB'S preset on my xti 2000

i'm not sure if i still need to connect my speaker cable to the 2 positive terminals (red banana plugs) or conf. my speakon cable to the +1 +2 although i've set the

amp to bridge mono or bridge subs

amp - XTI 2000

speaker - B&C 18 TBW100

8 Ohms - 96dB SPL

  • 1,500 Watts AES Standard
  • 3,000 Watts Program

4 POLE SPEAKON CABLE

Share this post


Link to post
Share on other sites

Hello and wolcome to the forums :)

Either way would work so which ever you feel more comfrtable with, if you need to dissasmble the rig many times I'd go the Speakon route, just make sure the polarity is correct acording to the manual (page 13, section 2.6.2) and if you go the speakon route make sure you mark the amp side of the cable clearly.

Share this post


Link to post
Share on other sites

Thanks Dakos, will go ahead and make the changes, I just wasn't sure if its a step needed although the amp was switched to bridge mode already.

Thanks again for your quick reply.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now