emachine87

filter settings in bridged mode

2 posts in this topic

I am looking for advice on lpf & hpf settings on xls series. My set up is xls2500, bridged (2) each connected to 1 or 2 HX118s subs (depending on room size)

xls1500, bridged (2) each connected to 1 or 2 yamaha S115IV (same as above)

I run thru a drive rack PA+ and have current firmware loaded

My question is what freq I should use in bridged mode for the LPF and HPF to best protect the speakers?

Share this post


Link to post
Share on other sites
I am looking for advice on lpf & hpf settings on xls series. My set up is xls2500, bridged (2) each connected to 1 or 2 HX118s subs (depending on room size)

xls1500, bridged (2) each connected to 1 or 2 yamaha S115IV (same as above)

I run thru a drive rack PA+ and have current firmware loaded

My question is what freq I should use in bridged mode for the LPF and HPF to best protect the speakers?

I couldn't find the manual of the Harbinger, I just found a bunch of meaningless specs, so I would recommend to start with these settings:

HPF at 40hz, 18dB/octave, LPF at 98hz, 18dB/octave. That's for the subs.

For the Yamaha 15s, 105hz HPF at 18dB/octave. All L&R type filters.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now