ontime1269

XTI 1000 Sound Cuts Out

7 posts in this topic

On my XTI 1000 the sound will cut out on Channel 2. It is driving 1 top crossed over at 90hz. Sometimes the sound will come back in on own its on but rarely. Turning the volume all the way up on my mixer always brings the sound back in. This will happen every 5 - 10 minutes or so. I have another XTI 1000 and a XTI 2000 and hooked everything up identically to those to see if there might be another issue within the signal chain. The other 2 XTI's worked flawlessly. Is there possibly a short of some sort within the XTI 1000 in question? Thanks.

Share this post


Link to post
Share on other sites
Hard to get any answers around here. I was finally able to get my amp repaired. Turned out to be a bad ribbon connector.

Good to hear you got it fixed, sorry I couldn't answer, not my strongest area.

Share this post


Link to post
Share on other sites

Hard to get any answers around here. I was finally able to get my amp repaired. Turned out to be a bad ribbon connector.

Do you know which ribbon connector? I have the same problem. I just have to tap on the unit and the sound comes back on.

Share this post


Link to post
Share on other sites

The ribbon discussed is the one linking the main board to the display board. Furthermore, I would suggest replacing the connector at the same time.

However, Crown has a direct replacement module.

A.

Share this post


Link to post
Share on other sites

Can you let me know what version of the display board you have? (the latest version is 138911-5)

Thanks!

A.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now