Sign in to follow this  
Followers 0
Mctwins

System Architect Kiosk Mode

4 posts in this topic

Hi

I have installed System Architect 2,2 version on my computer and I also installed at the same time System Architect Kiosk Mode.

When I open the System Architect Kiosk Mode I can't use this software. I have difficult to close it and use it as well as understanding what to with it. If I want to close it I have to use CtrlAltDelete buttons to exit the program. Is this normal??

Can I delete this program and only use System Architect 2,2 software?

Thanks

Share this post


Link to post
Share on other sites

Yes, this is normal. Just delete the Kiosk mode shortcut from the Windows startup directory so you can run SA 2.2 normally.

Share this post


Link to post
Share on other sites

Hi

It is deleted.

Some more questions.

On the software setting of channel 1 and 2 (MAi-5000) there is Auto stanby adjustments, what do I do with these feature? Nothing in manual.

I have 2 RJ-45 connecting input, is the second used for daisy chain, or??

What cable is best suited. I need around 3 feet of cable.

On back panel of the amp there is a flashing preset, what does it mean?

I have downloaded the new software for the amp. I just want to check witch is the latest software version for this amp.

I think the new version I downloaded was 1.0.9.3. I have to connect to the amp for verification.

If I use Y-link do I use the channel 1 input to feed the outputs of channel 1 and 2? Nothing in manual.

Is there any schematics for the MAi-5000?

Thanks

Share this post


Link to post
Share on other sites

Auto-standby shuts down the voltage rails if the threshold is not exceeded for x minutes. The turn-off delay sets x.

Yes, the second network port is for daisy-chaining more devices. CAT5 cable is standard.

The flashing preset LED basically means the amp is alive.

The latest firmware is always included with the latest version of Sys Architect, in this case, 1.0.9.3.

Yes, input Y uses Ch1 input only.

Schematics are available to service centers. However, depending on your situation, we can get you one. Please email me your request - kevin.heber@harman.com

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0