Sign in to follow this  
Followers 0

IQwic Responds but can't see

2 posts in this topic

I have a ct400 with the usp 3 card in it. When I'm' in iqwic I can change eq's, change the output gain. The whole 9 yards. There is signal passing through the amp and it is working normally. The problem is that I don't see input, output or thermal graphs. The other thing that I can not do is change the frequency of the noise generator. I can how ever control the volume of it. Even if there was no audio passing through it, the generator would make the bars. So there's something up. Any Ideas?

Forgot to add that error log pops up saying the device appears to be dead. I have changed out the network cables also.


Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  
Followers 0