Sign in to follow this  
Followers 0
hotgem

Itech advance features

3 posts in this topic

Hello,

how can I use the limiters in IT-4000, particularly in average watts. do I have to configure the monitoring page in the software.

Share this post


Link to post
Share on other sites

Hello,

You can use step through the advanced settings from the front panel LCD and turn on and set the average power limiters, or you can use the software and turn the limiters on from the control page.

Share this post


Link to post
Share on other sites

To clarify a bit further:

Average power limiters can be enabled or disabled from the front panel, but there is another setting some users may want to modify.

The average power limiter calculates power based on a nominal impedance setting that is configured in IQWic. On the "load monitoring" tab, set the nominal impedance to match the connected load. The average power limiter will then limit based on this value.

The peak voltage limiter can be fully configured from the front panel of I-Tech, and is another way to protect drivers when necessary.

Marc

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0