USP3 Reset Command?

2 posts in this topic

I'm currently using TCP/IQ UDP commands to communicate between a Crestron RACK2 processor and a MA5002VZ using a USP3 PIP. I would like to be able to reset the amplifier to factory defaults without having to physically push the reset at the amplifier or having to send multiple command strings resetting states.

I have scanned the .OIF command list and did not see a register state where I could set/reset the amplifier. Is there any single command I can send to the amplfier to have it reset to factory defaults?


Share this post

Link to post
Share on other sites

The cleanest way to do that would be to store a "blank" preset of factory defaults and just recall that when you need to zero the unit out.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now