Teoyaomqui

Members
  • Content count

    4
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Teoyaomqui

Contact Methods

  • ICQ
    0
  1. I though that the 2 MT-2400 would be enough for running serwin Vega subs 4 subs. Can anyone give me a ration of how many speakers per Amp would be sufficient? for Example: 2 18" to a XTi 2000. I know mix and matching is always wrong but, this is what I have: 4 Peaveys(1 horn and 2-15") 6 Peaveys(1 horn and 1-15") 2 made up cabinet (2-18") 2 Carvin (1-18") 4 Cerwin Vega (1-18") How much power would I need to run this system with out any problems or at least just run it. Thanks.
  2. Translation: Hi, I have a Crown k2 and I would like to know if I put it as mono bridge and I put two DAS Speakers of 700 Watts, At how many Ohms would the k2 would work if its rated at 2500 Watts in Mono Bridge mode. Can I hook up in bridge mode 4 Speakers of the same type with no risk of damaging the amplifier? If I plug in 4 speakers at 8 ohm, would the amplifier work at 4 ohms? I would Appreciated your answer. Thanks.(not exactly but thats close enough.)
  3. Thanks for the response. I though that the 2 MT-2400 would be enough for the 4 subs I was running. I will think about this setup. Can anyone give me a ration of how many speakers per Amp would be sufficient? for Example: 2 18" to a XTi 2000. I know mix and matching is always wrong but, this is what I have: 4 Peaveys(1 horn and 2-15") 6 Peaveys(1 horn and 1-15") 2 made up cabinet (2-18") 2 Carvin (1-18") 4 Cerwin Vega (1-18") How much power would I need to run this system with out any problems or at least just run it. Thanks.
  4. Hello, I have 2 MicroTech(or MacroTech the one with only One LED and no volumen nobs on front) 2400 and I use them on 4 Cerwin Vega Earthquakes. I have blown 4 of them using this amps and each speaker is rated at 1000 to 1200 peak and around 600 continues. My main question is, was I under powering the speakers that when I put too much program then got fried? or the other way around? Too much power for the speakers to handle. Am planing on using 6 Cerwin Vega speakers and getting a XTi 4000 to run them. Is that too much or not enough? Am thinking on getting 3 Amps from the XTi Series. The 1000, 2000, 4000 power amps. 1000 for tweeters, 2000 for mids and 4000 for the subs I have 6 Peavey SP1(1-15") and will plan on using them three way. Would that system be enough? could I use the MT-2400 to run the 6 Peaveys(1-15") with out burning them?