kevinkinchin

Members
  • Content count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

About kevinkinchin

  • Birthday 12/20/1963

Contact Methods

  • Website URL
    http://www.1spl.co.uk
  • ICQ
    0

Profile Information

  • Gender
    Male
  • Location
    Richmond, North Yorkshire, United Kingdom
  1. Hi, if you use the latest version of System Architect when you select an active device, ie the amp you want to talk to, it will offer you a firmware update which is later than 2.0.9.10
  2. Hi, i have an IT8000 that was doing the same thing, i sent it back to crown service dept in the UK and they fitted a new temp sensor and re-calibrated the unit. All fine now.
  3. Hi, just got an I-tech 4000 and it does exactly the same, power up ok and then after a few minutes both fault leds on and have to power off and on again to clear this fault. However a few minutes later does it again. Only 2.1 hours on the clock.! Just to let you know this was a power supply control pcb fault which was replaced and all is well with mine.
  4. Hi, just got an I-tech 4000 and it does exactly the same, power up ok and then after a few minutes both fault leds on and have to power off and on again to clear this fault. However a few minutes later does it again. Only 2.1 hours on the clock.!