• Content count

  • Joined

  • Last visited

Community Reputation

0 Neutral

About patrickm36

Contact Methods

  • ICQ
  1. I have an installed amp rack consisting of 2 ct810's and 1 ct 210. The 210 failed first, we replaced the usp2 chip then the amp failed again (indicated by ioc lights, slowly coming on then staying on) We have placed an 810 in place of the 210 with the chip in the 210 going into the 810. That amp seems to be working fine but now one of the original 810's is doing the same thing as the 210. The facility has had brown outs, i would say about ten over the course of 4 hours. We are wondering how voltage effects the usp chips or if there is any other reason the amps are failing. These amps are less than 2 years old and are run at very low settings ( podium mic, some media) Any thoughts?
  2. Thank you very much for the info!! And quick too!! I'm doing this today so i'll probably be back, thanks again!!
  3. I'm getting ready to change from USP2 to USP 3, All sound systems are programmed onto all amps, 1st, is there an easy way to copy those settings so i don't have to manually enter them? 2. What IQwic version do i need to run in order to update firmware on the new USP 3's, 3rd, the amps are used in conference settings, and we regularly use diff amps with different speakers. the sound is actually brought in so there would be no switcher, can i just use a crossover network cable to both monitor and change settings, and lastly if a crossover cable is ok then how many amps can be monitored before you need a switcher? Thanks for all your help!!!