• Content count

  • Joined

  • Last visited

Community Reputation

0 Neutral

About BaldGuyBrit

  1. Just wanted to say to Shane - Wow. What an excellent answer. Think I would have to read it a few times to understand. So glad I joined this forum.Very very cool.
  2. I appreciate your very fast response "down under". I have just updated firmware & installed band manager which is showing everything is ok. At the moment my one bass bin is working as it should now I'm configuring for the second. I think it may be something inside. I have to use them this wk d & for a big function next wk d ( I'm bringing backup powered subs) and then if the problem persists I'm dropping them off at my local Crown center. How are those Shelia's there mate. My dad served in Australia during WW2 as a pilot on the Lancasters.
  3. Forgot to mention. I've tried many different cables for the input. Also tried different config settings.
  4. Hello. First off I've been a Crown fan for many years & have never had any problems with the amps or blown speakers ( I have knocked the power out at a few venues with the older models!). I have a XTI2000 and have now replaced two cones - one on an EAW250 & a JBL JRX100. I'm currently running the amp with 2 JRX100 subs. The problem I'm having - It always takes a while for a signal to display on the amp. I'm running 2 QSC 12 powered for the high freq' & run a signal via a zone to the Crown amp. When I do get the signal & the bass bins push air - it may be a few minutes or a hour or so & no bass. There are no error messages on the amp ( which is still powered up). Last night, it happened again, and out of frustartion I tapped the amp near the input & it came on. I'm thinking this is an issue with the inputs - anyone else had a similar situation or is there some other setting I should be checking ? I'm very careful about my levels & always use limiting, but of course, still managed to blow 2 cones ( probably when the sub came back online). Any suggestions or help would be greatly appreciated. Steve