Yeahuwrite

Members
  • Content count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Yeahuwrite

  1. Hello friends - I desire to use (2) 4002's in bridge mode, and protect the speakers with the XTi's inboard limiter at a threshold around 1800-2000 watts continuous. What is the corresponding coefficient within the menu for setting this limit? Also, the manual states that both input channels must be fed, and then the signal is summed in bridge mode. Can I just feed one channel with signal, eg., channel one, and the bridge mode will still enact? Or, do I need a Y cable, as I am sending from stereo main outs and cannot merely run one side of the front of the house? Thank you.
  2. Hello friends - I desire to use (2) 4002's in bridge mode, and protect the speakers with the XTi's inboard limiter at a threshold around 1800-2000 watts continuous. What is the corresponding coefficient within the menu for setting this limit? Also, the manual states that both input channels must be fed, and then the signal is summed in bridge mode. Can I just feed one channel with signal, eg., channel one, and the bridge mode will still enact? Or, do I need a Y cable, as I am sending from stereo main outs and cannot merely run one side of the front of the house? Thank you.
  3. Thank you, Dakos. I do expect to use the inboard limiter to protect the speakers. Do I still need to feed BOTH inputs to have them summed at ahannel one output? Your speakers are 500W continuous and 2000W peak, but when you bridge the 4002 you get 2400W, that's way too much continuous power for this speaker, will you use the built in limiter to protect them? an external limiter? Yes, you need to rewire the amp side of the cable, for this and all the rest look at page 4, section"Factory Preset #2: BRIDGE" in the manual for detailed info about this.
  4. I just purchased two XTi 4002's and desire to bridge each one to power a single EAW Fr153z (3-way, 8ohm, 500 w). The manual states that I have to send to both amp inputs and they are summed out of Channel one. Can I just send a SINGLE input to channel one input, and they will still be summed, or do I need to get a Y cable? Secondly, is a standard, stock NL4 Speakon cable ALREADY configed to send this sum to the cabs, or do I need to rewire it? Thank you
  5. I just purchased two XTi 4002's and desire to bridge each one to power a single EAW Fr153z (3-way, 8ohm, 500 w). The manual states that I have to send to both amp inputs and they are summed out of Channel one. Can I just send a SINGLE input to channel one input, and they will still be summed, or do I need to get a Y cable? Secondly, is a standard, stock NL4 Speakon cable ALREADY configed to send this sum to the cabs, or do I need to rewire it? Thank you.