DavidWSims

Members
  • Content count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

About DavidWSims

  1. Thanks for the reply, I can't read the text on the picture you attached, I think that I could make out that the white wire and the shield were the two outside connections and the red wire is the center connection. Is this correct? I can identify where the shield was terminated so if you can tell which wire to connect to the center pin I will have all the information I need to make the repair. I was able to get that section of the document blown up and saved as a .pdf. Let me try and repost it. PZM_6Dwiring.pdf Thanks again for your help. This is exactly what I needed.
  2. Thanks for the reply, I can't read the text on the picture you attached, I think that I could make out that the white wire and the shield were the two outside connections and the red wire is the center connection. Is this correct? I can identify where the shield was terminated so if you can tell which wire to connect to the center pin I will have all the information I need to make the repair.
  3. We have a PZM-6D installed in the piano at church; someone recently pulled the cable out of the XLR connector. I would like to re-solder the wires to the circuit board inside the connector, but I can't find a wiring diagram. The microphone cable has a red conductor, a white conductor and a shield. The circuit board has three connections points, the left most is where the shield was connected, but I can't tell where the other conductors were connected. Can I get a diagram showing the wiring terminations?