Avalon

Members
  • Content count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Avalon

  1. :Simple rule of thumb: don't mix different speakers with different characteristics together on an amp channel. You could run mono signal to both channels of the amp, and put both Bose 901's on one channel, and put the RCF speakers on the other channel. This would put the amp at 4 ohms, which is not a problem. You still need an amp for the Bose bass speaker. Hi, Thanks for the advice on the connection, I will do with a bit of help with that again..as said above to run a mono signal to both channels, how do i do that. Should I run the amp on bridge-mono mode. Also If I have each of the Bose 901, and a RCF on each channel.I guess the Impedance will remain the same i.e. 4 ohms. That is how it is running now. Do you think I will have a problem. As for the B1, if I connect it with addition to the bose 901/rcf on a single channel. Will it pose a problem, since the output on 1 channel will be louder/load will be higher than the other. Sorry for all the trouble, but I just need all the help I can get, before I do something wrong.. Thanks.
  2. Hi, As I am pretty new to this place, I would like you all to assist me if possible with some connections I need to do with the below mentioned speakers. I am using the XLS602D amplifier, and the speakers I have is as below..Could you please tell me how I can connect them, without damaging the amplifier or the speakers. I have read somewhere that if the speakers are connected in a Series/parallel way, then there is a constant 8 ohms load on the amplifier...Can someone please help, this is very confusing.. Speakers : Bose 901 (450 Watts per channel, 8 Ohms) 1 Pair : Bose B1 Bass (125 Watts, 8 Ohms) 1 Speaker : RCF (500 Watts per channel at 8 Ohms) 1 Pair (L12110pk) Thanks.
  3. Hi, As I am pretty new to this place, I would like you all to assist me if possible with some connections I need to do with the below mentioned speakers. I am using the XLS602D amplifier, and the speakers I have is as below..Could you please tell me how I can connect them, without damaging the amplifier or the speakers. I have read somewhere that if the speakers are connected in a Series/parallel way, then there is a constant 8 ohms load on the amplifier...Can someone please help, this is very confusing.. Speakers : Bose 901 (450 Watts per channel, 8 Ohms) 1 Pair : Bose B1 Bass (125 Watts, 8 Ohms) 1 Speaker : RCF (500 Watts per channel at 8 Ohms) 1 Pair Thanks.